Clutch
#1
Clutch
So im putting together my clutch. There is the flywheel then the disc then the piece that goes over the disc and bolts up to the flywheel. The part that bolts to the flywheel does not go all the way down. Then i threw the stock one back on and it still doesnt sit flat on the flywheel... Any ideas? Is it made to do this and from the bolts getting tighter will it make it sit flat? Thanks!
#6
Re: Clutch
Are you sure you should be doing this?
Just tighten it down, do you think if there was no excess contact between the Flywheel to the clutch to the PRESSURE PLATE that it would hold power!
It's called a Pressure plate, and there is a reason why it's called that!
Just tighten it down, do you think if there was no excess contact between the Flywheel to the clutch to the PRESSURE PLATE that it would hold power!
It's called a Pressure plate, and there is a reason why it's called that!
#7
Re: Clutch
Originally Posted by 91backinblack
Yeah im just doing this on my table... the flywheel isnt on the motor yet. And its on the right way.. i have the part that says the flywheel side on the flywheel. i will look again tonight.
good luck
Thread
Thread Starter
Forum
Replies
Last Post
Jmunk
Turbo Parts For Sale
0
03-26-2006 09:11 AM
nyc86zc
General Discussion
15
09-17-2005 03:30 PM