chipped my crank pulley - ok still? (pic inside)

Reply Subscribe

Thread Tools

Search this Thread

May 21, 2007 | 11:33 PM

WTF

Thread Starter

3.0 BAR

Joined: Jan 2006

Posts: 2,057

chipped my crank pulley - ok still? (pic inside)

didnt know they were so brittle, wacked it with a hammer to loosen it up and chipped a piece off.. its from a ls motor

should this be ok to use ? or is it gona be off balance bad or some ----

May 21, 2007 | 11:35 PM

89sipimpin

!! UNCONFIRMED EMAIL !!

Joined: Dec 2004

Posts: 665

Re: chipped my crank pulley - ok still? (pic inside)

I've used worse on my last LS motor, and ironically it was the only motor I had that didnt spin a bearing lol.

May 21, 2007 | 11:35 PM

HMTguy

Guest

Posts: n/a

Re: chipped my crank pulley - ok still? (pic inside)

Get a new one. WTB forum, someone will hook you up cheap.

May 21, 2007 | 11:37 PM

ghettoturbo

Guest

Posts: n/a

Re: chipped my crank pulley - ok still? (pic inside)

ill sell you the one i chipped

May 21, 2007 | 11:38 PM

Zeniceguycrx

3.0 BAR

Joined: Feb 2006

Posts: 3,905

Re: chipped my crank pulley - ok still? (pic inside)

what is that the ac belt?
run it, if you toss a belt change it

May 21, 2007 | 11:41 PM

WTF

Thread Starter

3.0 BAR

Joined: Jan 2006

Posts: 2,057

Re: chipped my crank pulley - ok still? (pic inside)

its the power steering belt on that part

May 21, 2007 | 11:45 PM

turbohf

!! UNCONFIRMED EMAIL !!

Joined: Dec 2002

Posts: 6,654

Re: chipped my crank pulley - ok still? (pic inside)

bah its fine....

i have a CTR pulley that has a chip in it (about half that size) and its obviously on the alternator belt part, been like that for over 3k miles with absolutely no issues....

May 21, 2007 | 11:47 PM

WTF

Thread Starter

3.0 BAR

Joined: Jan 2006

Posts: 2,057

Re: chipped my crank pulley - ok still? (pic inside)

how about i add some jb weld lol,

or cut a little off the opposite side.. probly wouldnt help

May 21, 2007 | 11:49 PM

turbohf

!! UNCONFIRMED EMAIL !!

Joined: Dec 2002

Posts: 6,654

Re: chipped my crank pulley - ok still? (pic inside)

Quote:

Originally Posted by WTF

how about i add some jb weld lol,

or cut a little off the opposite side.. probly wouldnt help

omg that piece weighs like 1/4 of a gram!!! your fine... even after 100K when it finally ***** your oil pump up, its a ------ LS... youll live, world will continue to spin, etc...