i plan on my motor being finished by december, and i dont want to waste time tuning and ---- n/a so im building the motor throwing on my turbo and using crome pro. i read this http://www.mototuneusa.com/break_in_secrets.htm but how do i tune it before i go full throttle launching?? this will be my first time tuning and i want to break the engine in right. its a y7 z6 low compression with t3/t4oe.

should i just make the best basemap i can wait for it to warm up and just keep an eye on the wideband?

 

find some one with a simalar setup and get there map. use that as a basmap and work on it from there.

 

how do you guys break in your motors? gently or hard on it like that page i found in the newb section.

 

iv only broke in one motor and i was pretty hard on it. i redlined it once or twice and changed the oil often.