b16b pistons on b18a rods in b18a block
10-16-2007, 01:18 AM
#12
!! UNCONFIRMED EMAIL !!
Join Date: Dec 2002
Posts: 6,656
Re: b16b pistons on b18a rods in b18a block
Originally Posted by bitchasscracker
he is asking if ctr pistons fit on b18a rods in a b18a block
Originally Posted by turbohf
your an idiot... read what i wrote again... :1
so to recap...
bitchasscracker = idiot that doesnt know wtf he is talking about
B16B pistons + PR4 rods = grinder to get them to fit
10-16-2007, 01:22 PM
#13
0.0 BAR
Join Date: Jun 2003
Posts: 0
Re: b16b pistons on b18a rods in b18a block
Originally Posted by turbohf
B16B pistons + PR4 rods = grinder to get them to fit
10-16-2007, 03:17 PM
#14
!! UNCONFIRMED EMAIL !!
Join Date: Dec 2002
Posts: 6,656
Re: b16b pistons on b18a rods in b18a block
Originally Posted by crxvtec91
Yes but it also depends where he gets them, a few of my friends got them from ebay and no need to grind down while others did.
you sure those where actually B16B/PCT pistons and not just PR3's?
10-16-2007, 11:51 PM
#16
1.5 BAR
Join Date: Aug 2003
Posts: 1,068
Re: b16b pistons on b18a rods in b18a block
ok I have done this and they do work. but you must shave 1mm off the small end of the ls rod. if you are going to use the b16b/pcts you will be in the 12ish cr and depsite what people say this will run just fine on pump gas with moderate tuning. they really run best with 110+ but will make good power on pump. look to make in the high 190whp to low 200's with a set of regrinds on that setup.
10-17-2007, 02:33 AM
#17
3.0 BAR
Join Date: Apr 2005
Posts: 4,890
Re: b16b pistons on b18a rods in b18a block
Originally Posted by crxvtec91
Yes but it also depends where he gets them, a few of my friends got them from ebay and no need to grind down while others did.
thank you for the ebay confermation like i said. seem i do know what i'm talking about, my friend did buy them off ebay and they did fit ls rods.
10-21-2007, 01:16 AM
#20
3.0 BAR
Join Date: Jan 2004
Posts: 5,933
Re: b16b pistons on b18a rods in b18a block
Originally Posted by jklaudio
hahahahah ------ nogs....... got the pct pistons to go in to the pr4 rods with no mods.....just letting yall know what going on!!!!
Negative
