oneamongthefence

I just installed a new motor and transmission (D16A6) and when I started it up, I noticed that my axles are spinning, not very fast though. I can stop them with my feet but they start back up again when I let go. The car is on jackstands. Did I install the tranny onto the block incorrectly? And they are spinning in a direction as to move the car forward. Thanks in advance.

1991civicsi

Its normal

Bone1

5 roller bearings cause it.

Zeniceguycrx

put it in 5th and tray to hold them when someone hits the gas


also put a set of visegrips on the otherside first

Bone1

with tranny fluid below freezing