ARP studs in LS help
#1
ARP studs in LS help
i got some ARP studs im about to install, currently taking the head off, anyone know a good amount to torque them too? i've read anything from 65-85 ft-lbs so i was go go for 70ish
i think my box was missing instructions, or maybe they jsut figure you know... also what do you gyus do for putting the studs in the block, hand tight snug with a allen wrench or what?
lube everthing pretty much but the middle of the stud?
thanks
i think my box was missing instructions, or maybe they jsut figure you know... also what do you gyus do for putting the studs in the block, hand tight snug with a allen wrench or what?
lube everthing pretty much but the middle of the stud?
thanks
#8
Re: ARP studs in LS help
got these in but im not very confident in how they went in, i was watching the stud carefully in between turns when i was doing the final torque down and i seen a few of the studs turn a little
think next time i would put thread lock on the end going into the block and let it sit over night, or try the ball bearing in the block hole trick
having to go buy a 12pt 1/2" deep socket was pretty inconvenient, who uses 12 point nuts anyways?
think next time i would put thread lock on the end going into the block and let it sit over night, or try the ball bearing in the block hole trick
having to go buy a 12pt 1/2" deep socket was pretty inconvenient, who uses 12 point nuts anyways?
#9
Re: ARP studs in LS help
Originally Posted by WTF
got these in but im not very confident in how they went in, i was watching the stud carefully in between turns when i was doing the final torque down and i seen a few of the studs turn a little
think next time i would put thread lock on the end going into the block and let it sit over night, or try the ball bearing in the block hole trick
having to go buy a 12pt 1/2" deep socket was pretty inconvenient, who uses 12 point nuts anyways?
think next time i would put thread lock on the end going into the block and let it sit over night, or try the ball bearing in the block hole trick
having to go buy a 12pt 1/2" deep socket was pretty inconvenient, who uses 12 point nuts anyways?
#10
Re: ARP studs in LS help
don't worry about the studs, the stud kits works differently than the bolts, the stock bolts, when you tighten them, they exert a downward pressure on the head to keep it tight, but with the studs, since they are just threaded into the block, when the nut is tightened not only is there a downward pressure on the head, but since you are tightening the nut, it pulls up on the stud, stretching it, this stretching exerts a pre load on the bolts which keeps them very tight for extended periods of time.