Anybody put a d15b7 in a crx with obd0 dizzy?
The reason I ask is if you did how did you get it to work. I know the dizzy will mount up but I think that it is upside down and when I do mount it it hits some sensors.
|
Re: Anybody put a d15b7 in a crx with obd0 dizzy?
all obdo/1 non vtec dist. have the same bolt pattern
|
Re: Anybody put a d15b7 in a crx with obd0 dizzy?
2 Attachment(s)
Yes I know that they have the same bolt pattern but the dizzys mount 180 degrees from each other. See where the coil is at on both of them?
Attachment 28530 Attachment 28531 |
Re: Anybody put a d15b7 in a crx with obd0 dizzy?
Originally Posted by chris
all obdo/1 non vtec dist. have the same bolt pattern
So whatever you're doing, if it's not fitting, it's not right. |
Re: Anybody put a d15b7 in a crx with obd0 dizzy?
I don't think that you understand. Both dizzys fit. I know they bolt up. I have the obd0 on there right now. I have spark. I have fuel pressure but I am not sure if the injectors are firing off now. I can't smell fuel any more. why wouldn't I be smelling any fuel?
|
Re: Anybody put a d15b7 in a crx with obd0 dizzy?
Need more details.
|
Re: Anybody put a d15b7 in a crx with obd0 dizzy?
I looked at all of those here is the low down.
I picked up a d15b7 had it installed by a shop. they did a very good job but they wouldn't put in my wiring harness because they said it was "hack up" but it just because it was an hf harness and I had to switch some things over. But it ran before with the old engine. So I checked the coil, igniter, fuel pressure, spark and most everything I could think off. Its not throwing codes What else do you need to know? Do you know how to check and see if the ecu is sending injector pulses? |
Re: Anybody put a d15b7 in a crx with obd0 dizzy?
grounds
also pull an injector out of the fuel rail and manifold. turn the key to 2nd aux on the ignition you have spray you have fuel where it needs to be spark fuel ground correct car will start |
Re: Anybody put a d15b7 in a crx with obd0 dizzy?
Originally Posted by crxrx7
I looked at all of those here is the low down.
I picked up a d15b7 had it installed by a shop. they did a very good job but they wouldn't put in my wiring harness because they said it was "hack up" but it just because it was an hf harness and I had to switch some things over. But it ran before with the old engine. So I checked the coil, igniter, fuel pressure, spark and most everything I could think off. Its not throwing codes What else do you need to know? Do you know how to check and see if the ecu is sending injector pulses? like chris says, fuel, spark, grounds and it'll run. |
Re: Anybody put a d15b7 in a crx with obd0 dizzy?
Thanks I will try that and see what comes up.
|
All times are GMT -5. The time now is 08:47 AM. |
© 2024 MH Sub I, LLC dba Internet Brands