just got a 92 civc, just wonna do a head swap, from what car, and what will I need?? oh!!! it's a 4/door, 5spd DX...

 

92 ex/si head ecu and wiring

 

you dont need the whole harness from an ex. you can use your stock harness, you will need to run two wires for the ecu for vtec sol. and vtec oil press. check out the site for the wiring.


www.hasport.com

 

I'm sorry my fault the car is a 91 DX, and my problem is that it's a dual port injection system, and I wonna turn it into a four port injection. I have a head, and the manifold to go with that head, the injectors, the ecu, etc... but my problem is I know that I can't just throw on the head, and expect the car to start right up so what else do I need wiring wise...

 

what year and model is the head from?

 

well really it's off of a 88 Honda CRX si

 

you need the injector resistor box and the wiring for the new injectors. This is a common swap, check the net there is alot of info on this.

 

88, where do I check for this what do I type in the engine search?

 

a resistor box is something you will need to get from a junk yard. its a little greyish/silver box that is on the driver sided near the shock tower. It looks like a heat sink on a amp / compter.

 

88, I was just told that I don't need to change the head for what I wonna do, I was just told that all I need to do is change my intake mainfold. Oh!! I know what the resistor is.. "remember" my goal is to turn my dual injection system to a regular 4 injection system.. thanks...