2 intake Manifold Y8/Z6 Which is better?
#22
Re: 2 intake Manifold Y8/Z6 Which is better?
Originally Posted by crxrx7
Just buy the edlebrock mani.
You ever been on a flowbench with d series aftermarket parts
The skunk2 manifold
edelbrock are hype
design is half assed
they took a b16a manifold plenum and threw it on to long of runners
Your also the guy who cant get a simple swap to start
dont ----- up my section or Ill just delate all your threads
#23
Re: 2 intake Manifold Y8/Z6 Which is better?
Well its not the first time I ever swapped an engine. Something is missing out of the picture for this swap. I'll let you know what the problem was when it does run. And I am ignorant of the fact with the edlebrock manifold. I am not a dumb *** I just didn't know.
#24
Re: 2 intake Manifold Y8/Z6 Which is better?
Originally Posted by crxrx7
Well its not the first time I ever swapped an engine. Something is missing out of the picture for this swap. I'll let you know what the problem was when it does run. And I am ignorant of the fact with the edlebrock manifold. I am not a dumb *** I just didn't know.
I have worked on alot of d series all motor builds and know what works. Wanna spit brand name crap and say its the ---- try it h-t not here
simple
#25
Re: 2 intake Manifold Y8/Z6 Which is better?
I just picked up a z6 yesterday i'm building it for boost, You're saying I should just stick with the z6 intake mani? I'm working on porting & polishing the head today but didnt really want to mess with the manifold.
#26
Re: 2 intake Manifold Y8/Z6 Which is better?
Originally Posted by ifly87
I just picked up a z6 yesterday i'm building it for boost, You're saying I should just stick with the z6 intake mani? I'm working on porting & polishing the head today but didnt really want to mess with the manifold.
you have more of a chance of ------- ---- up porting the head than the mani, a simple 1" mani/head port match is all i'd ever attempt myself
#27
Re: 2 intake Manifold Y8/Z6 Which is better?
well for a novice head porter you wont make power just letting you know your kinding wasting your time
if all your doing is a scuff and buff good luck
Most heads take 20+ hours of tough labor with very heavy cutters
if all your doing is a scuff and buff good luck
Most heads take 20+ hours of tough labor with very heavy cutters
#29
Re: 2 intake Manifold Y8/Z6 Which is better?
Originally Posted by ifly87
I am not looking to make the ports huge, I just want to open them up a little but mostly polish them up. I know it will take some time.
Basic port matching doesnt make power just letting you know
flowbench doesnt lie
track times dont lie
Thread
Thread Starter
Forum
Replies
Last Post
2stockrocketz
General Discussion
12
11-01-2005 05:39 PM