Originally Posted by burkej62

No you asshat the extra wire is the ground, it was common to run just two hots and a N but now everything is a 4 wire feed, usually. Capping off the white wire and not using it would mean you have 240 volts . Besides the point, your welder is a normal appliance just plug it in anywhere.

Originally Posted by c0mpl3x

ive got the same welder on a 30amp circuit, using a 30amp 110v sized horizontal plug. works prefectly fine :)

on a side note, pick up 10-15ft of 12/3 multi strand and throw an extension cord on that ----

Originally Posted by burkej62

You just proved yourself wrong cock smack . 14 gauge = 15 amps, im no genius but 15 < 23



It pulls 23 amps, thats defiantely not ------- 14 gauge so bend the ---- over and take it like a man 14 is good for 15 amps , which work would for the specs that were listed, but if you had a ------- brain you would see we all ready came to the idea those were the WRONG specs! It's a 230 volt , 30 amp machine. And it is most likley a 4 wired feed , you just dont see the 4 wire because the ground go right to frame ! Any extension cord at all would at least need to be 10 gauge wire. 12 gauge is rated only for 20 amps . Go get a damn dryer plug all ready as has been mentioned. just find whatever fits your receptacle .




Go ahed argue i can list the ------- NEC article for ya too

Originally Posted by Harbor Freight product subscription

nput: 230V, 60 Hz, single phase; Welding current range: 30-120 amps; Duty cycle: 15% @ 115 amps; Draws 15 amps @ 230V; Max. open circuit voltage: 36V; Weldable wires: .023", .030", and .035 steel or stainless steel; .030" and .035" aluminum; .030" flux core

Originally Posted by c0mpl3x

---- off twatcrust, the welder comes with 14ga STANDARD

Originally Posted by Turblow

My first choice, is white to white, black to black and green to red and the loose uncoloured wire from the plug to nothing. But I dont know what Im doing or is something needs to be grounded special at the welder or something

Please inform me guys

THanks

Originally Posted by burkej62

All right then get your self a damn dryer cord all ready ! If it's on a 30 amp breaker it has to be wired with 10 guage wire . The NEC dictates that everything must be of equal ampacity , to do otherwise would be illegal and a fire hazard. All you have to do is get a freakiing dryer cord. Unless this is a pure 240 volt machine it will need a neatrel docotor boost.

Look on the welder where the wire attaches there should be a red , black , white and then a green ground screw somewhere . Find the cord that matches your outlet and your good to go .