is there a way to get rid of 3" of slack from my throttle cable?
#1
is there a way to get rid of 3" of slack from my throttle cable?
i'm doing an ls/vtec install right now, and the cable has about 2-3" to much between the little ball and the adjusting nuts. any idea how to get rid of that slack?
long time-no post, but H-T is worthless
long time-no post, but H-T is worthless
#3
Re: is there a way to get rid of 3" of slack from my throttle cable?
im sorry, but im a ------- retard, and even i know the answer to this one
so your doing a ls/vtec.. but you cant figure out how to get rid of throttle cable slack :1
so your doing a ls/vtec.. but you cant figure out how to get rid of throttle cable slack :1
#5
Re: is there a way to get rid of 3" of slack from my throttle cable?
the distance between the closest to the end adjustment nut and the actual end of the cable is too long. i cant just "tighten the nut" till its snug.
#7
Re: is there a way to get rid of 3" of slack from my throttle cable?
Originally Posted by 88dx
I always cut and weld an extension peice on the bracket but really u can just buy the right cable
#8
Re: is there a way to get rid of 3" of slack from my throttle cable?
I am actually using a gsr TB on a d16 LOL
what you need to do is to move the TB bracket up by using just the top bolt, then route the TB cable over the fuel filter side and it will fit. the cable does blind a LITTLe tho.
what you need to do is to move the TB bracket up by using just the top bolt, then route the TB cable over the fuel filter side and it will fit. the cable does blind a LITTLe tho.
Thread
Thread Starter
Forum
Replies
Last Post
TTC
General Discussion
16
04-22-2007 03:10 PM
70Challenger
Wanted
1
06-22-2006 01:56 AM