Re:Sneak peak of my HM-ITB's
 

I'm using the Zdyne SECU, hopefully it will work ;) I'm looking forward to the challenge ;D

Re:Sneak peak of my HM-ITB's
 

that is going to sound raw! your torque curve will be all or nothing just like your throttle body will be all open or nothing.

NEUMAN

Re:Sneak peak of my HM-ITB's
 

mad props for the ITB setup, you should make a mild cowl hood and a scoop down to them for mad air intake. That'd be sick. I can see issues with the MAP reading, and what about idle control? Just leave them cracked a bit and let her rev? Seems like it would be tough to get that working alright...

Re:Sneak peak of my HM-ITB's
 

for idle i would just tighten the throttle cable, then it will be open like 2-5% at a min at all times...think that might work?

neuspeedescort, that Escort roll in Everett??

Re:Sneak peak of my HM-ITB's
 

Well, as far as Map and idle are concerned, a small vacuum log connected to all 4 runners should smooth things out. The IACV could then be connected so that it bleeds into the vacuum log. Atleast this is what Jay and I plan to to when we hook his ---- up. Im sure we will run into small problems, but nothing a PGMFI.org rom editor wont fix ;)

Whats the ETA on your ---- Jeff?

Re:Sneak peak of my HM-ITB's
 

The ITB's have a Throttle stop that is adjustable, so I will just have the butterflies slightly cracked open to keep it running. Its going to be a pain in the ass to get running right, but I'm determined :)

btw, there might be a little direct port nos with this setup ;D

Re:Sneak peak of my HM-ITB's
 

BTW... I could use another Engine stand for Christmas! >:(
hum i might be able to get you another but in all truth you said "do what ever with that ---- out there it doesnt meen anything to me" :-\

but on the same christmas present note i sure could use a zc or a zc that needs to be rebuilt ;)

Beau

Re:Sneak peak of my HM-ITB's
 

i'll get you an engine stand for xmas, but, yes, i need a built b18 bottom end please ;)

Re:Sneak peak of my HM-ITB's
 

i think i see what you're going to be building in that bottom pic. i figured you would try it sooner or later. good luck.

Re:Sneak peak of my HM-ITB's
 

the log should work, and if your using ish from pgmfi, you can just disable i IACV and use it as a paper weight.
K.I.S.S.