project: getting up to interstate speeds *NOW WITH VID*
#33
Re: project: getting up to interstate speeds *NOW WITH VID*
well the new clutch is going in tonight, and should hold just fine. it is a act extreme pressure plate with a oem disk.
trying to get this ready for the track on sat.
also just got som 20x8x14 slicks for it to.
trying to get this ready for the track on sat.
also just got som 20x8x14 slicks for it to.
#35
Re: project: getting up to interstate speeds *NOW WITH VID*
Damn now THATS how you do it! ------- love it!
I would really like to see under the heat shield with the turbo on, to see how you routed the downpipe and kept ac etc. Also while keeping ac how did you route the charge piping? I imagine with the side mount it made it a bit different but most people run it through the hole for the receiver/drier, but with ac that hole is a no-go. Im just tryign to get an idea of where I can route my pipes while keeping ac.
I would really like to see under the heat shield with the turbo on, to see how you routed the downpipe and kept ac etc. Also while keeping ac how did you route the charge piping? I imagine with the side mount it made it a bit different but most people run it through the hole for the receiver/drier, but with ac that hole is a no-go. Im just tryign to get an idea of where I can route my pipes while keeping ac.
#37
Re: project: getting up to interstate speeds *NOW WITH VID*
Originally Posted by turbo4life
buy a quality clutch with a "heavy" pressure plate.. no Chinese stage 3 that is actually softer than oem
Thread
Thread Starter
Forum
Replies
Last Post
fastcrx
General Discussion
15
02-21-2006 10:00 PM