Pilot bearing for d16a1? does it have one?
#1
Pilot bearing for d16a1? does it have one?
Hi, I've run into another problem. Does anyone know if a d16a1 has a pilot bearing (flywheel bearing?), maybe the zc is the same? I picked one up from carquest and it is definitelly not the right one. The chiltons manual points to one in a picture but it is very vague. But I went back to check and it was the part number they had in the book. Any expirience you might have with this would greately be appreciated.
Thanks,
Conor M.
Thanks,
Conor M.
#7
Re:Pilot bearing for d16a1? does it have one?
When I took off the clutch from my brown top ZC1...surprise surprise..no pilot bearing .
It always ran good like that...I took of the flywheel and the block is made not to have a pilot bearing.
I put in a bigger flywheel with the pilot bearing and the pilot bearing got pressed out to the other side...taking out a piece of the middle of the flywheel.
It always ran good like that...I took of the flywheel and the block is made not to have a pilot bearing.
I put in a bigger flywheel with the pilot bearing and the pilot bearing got pressed out to the other side...taking out a piece of the middle of the flywheel.
#9
Re:Pilot bearing for d16a1? does it have one?
I know. but there is a groove on the crank that makes room for the pilotbearing part that sticks out to fit.
My ZC1 flywheel doesn't use a pilot bearing...I'll take pic's when I get home. The hole in the middle is the same diameter as the pilot bearing hole.
My ZC1 flywheel doesn't use a pilot bearing...I'll take pic's when I get home. The hole in the middle is the same diameter as the pilot bearing hole.
Thread
Thread Starter
Forum
Replies
Last Post
turboboy
General Discussion
2
03-07-2005 06:05 PM