I want to get a rx-7 for a project car. They sell for $500 with blown engines all the time. They are light, rwd, huge transmission tunnel.

I'de like to put a Toyota 1UZ-FE in there. 4.0 all aluminium V8. 32valve, quad cams, forged crank and rods. 250hp, 260tor. Considerably lighter and smaller than a SBC.
http://www.1uzfe.com/
They sell for $1000 from engine importers. Use a supra 5speed with an adaptor plate.
Twin turbo that bitch hmt style.

 

yeah that would be the ----

 

kain, do you think I should put some premix in mine even though I have the oil injectors still there? I have never done this and I really doubt the old owner did it and not to mention the car sat for 3 months .

 

well if you did it, it wouldnt hurt one bit. infact it might run a lil bit better.

i mix one ounce of premix walmart 5 dollar 1 gallon premix with one gallon of any fuel i put in there.


this doesnt smoke at all, and you cant smell anything. infact it made the gasoline smell go away.

 

whats the name of the brand you bought? Also were would it be located with in the store, lawn and garden

 

go the rx7club.com. I seem to remember a certain type of oil you want to mix in, not just any 2 stroke oil. but kain is right, you might aswell premix, espcially if you have a S5, since S5s have electric oil pumps and they tend to ---- up. The oil pump in my 87 T2 (mechanical) wasn't even working when I pulled the engine apart for a rebuild.

 

good ---- i wanna see a fat *** burn out vid on here when that ***** done...i wanna put a 13Bre in my 240sx but its relly costy an i relly dont have the time to do that kinda swap.

 

An RX7 will be my next car, and I have both a 302 and a 350 sitting in my garage, gotta decide which one I want to put in it. Are you familiar with the EFI swap or just the carb swap? I'm debating which one I should do