My HMT, finally finished.
#44
Re:My HMT, finally finished.
That 1.5" oulet.. wow and i thought that the greddy 15g was small at 2". The setup looks good though
You said you couldn't find pipes with small enough bends?? I ordered mine for JCW and their bends were just about right, I had to add to them, but then again, my setup is a little different route then yours.
If you don't replace any of those couplers, you may want to replace the one on the turbo, I have a reducer for my 2.5" pipe to the 2" to the turbo and it kinda gets a little mushy when it gets hot, but it holds up to the 5psi I am running for now.
You said you couldn't find pipes with small enough bends?? I ordered mine for JCW and their bends were just about right, I had to add to them, but then again, my setup is a little different route then yours.
If you don't replace any of those couplers, you may want to replace the one on the turbo, I have a reducer for my 2.5" pipe to the 2" to the turbo and it kinda gets a little mushy when it gets hot, but it holds up to the 5psi I am running for now.
Thread
Thread Starter
Forum
Replies
Last Post
USS
General Discussion
39
01-18-2006 02:16 PM
wdwalker
Forced Induction
40
05-21-2005 12:18 PM