B16aJunkY

i know this is a really stupid question. buts i cant aford to wast alot of time on my daily driver. i got halo projector lights. and i don;t want to go taking things off. to me it looks like i have to take my front bumper off. but i only see some screws in the fender well.. but it still wont come off? anyone know where the rest of them are?

91 dx hatch

SkunT

right up top, near the hood latch. there is a long black peice, that is screwd to it. i htink there are 3 screws that are there. phillips, cant tell you the size.

hope i helped.

95RedEX

I'd run out and check but it's ------- cold out.

I'd say 3 to 5 phillips head screws on top/middle, 2 screws in the fender wells and 3 bolts underneath.

Ricer

B16aJunkY

there is no screws on the top. only 2 ph's on each fender and 2 10mm on the bottum. and i'm not a ricer.. my head lights got a hole in them.

spoon fed

this is in you 91 right?

robs99si

it takes 5 minutes to take off the front bumper. 2 screws, 1 in each fender well. some clips, and some 10mm bolts holding plastic shields. the bumper is actually a bumper/cover. it isn't gonna weigh and has no reinforcments. just a molded piece of plastic.

B16aJunkY

yea i figured i got it on now.. but 2 wires for the high beems. red and black. it says to hook the black to the negitive side marker. but it dosn't say where the red one go's i tryed ground.. and nothing. i tryed hooking it to 12v's and nothing.

SkunT

oops, i was thinkin for an eg. :P

juli0_bustamante

it takes forever to remove the bumper on an EF!!!!

there are some under the filler piece and even that takes some ------- majic to remove.. the ones on the bumper that require a phillips are tricky cause you can strip them. so be carefull.

easiest way is to remove the ones o the side ( wheel well area ) and then 2 little phillips that are on each end of the bumper right along the filler piece area on the ends..look for those you can see them... then the ones that have those straps that go to the bumper support ( black metal thing that keep your car from ------- up in an accident) those are like 4 and use a 10mm head. then remove the ones from the bottom and your set. be careful cause it will require some patience and always take your time.

B16aJunkY

cool thanks! there on.. and a hole lot better then stock.. but i cant get the high beem to work. there is an extra red and black wire coming from the high beem light. the directions to that says to hook the black to the negative or the corner light. when i did that nothing happened. any ideas?