clutch ?
#21
Re: clutch ?
Originally Posted by rudebwoy
I think I found something that may hold up for a little bit.
http://www.-------------/catalog/stag...kit-p-158.html
http://www.-------------/catalog/stag...kit-p-158.html
* 105% Clamp Increase, 415 ft/lb Torque Capacity
* Included: Pressure Plate, 6-Puck Sprung Disk, Throwout Bearing, Pilot Bearing, and Alignment Tool
* Fits 90-91 Acura Integra
#22
Re: clutch ?
that would be for a cable transmission, I have hydrolic.
when I say I am confused I mean man I don't what to do about this clutch situation.
I came up with a decision, I am going to install my old clutchmasters fx500 pressure plate with Gripforce disc used but in good shape, untill I sell enough ---- ti raise $1200 and buy a competition trin disc fron the cron.
when I say I am confused I mean man I don't what to do about this clutch situation.
I came up with a decision, I am going to install my old clutchmasters fx500 pressure plate with Gripforce disc used but in good shape, untill I sell enough ---- ti raise $1200 and buy a competition trin disc fron the cron.
#23
Re: clutch ?
Originally Posted by rudebwoy
I think I found something that may hold up for a little bit.
http://www.-------------/catalog/stag...kit-p-158.html
http://www.-------------/catalog/stag...kit-p-158.html
#25
Re: clutch ?
Originally Posted by rudebwoy
that would be for a cable transmission, I have hydrolic.
when I say I am confused I mean man I don't what to do about this clutch situation.
I came up with a decision, I am going to install my old clutchmasters fx500 pressure plate with Gripforce disc used but in good shape, untill I sell enough ---- ti raise $1200 and buy a competition trin disc fron the cron.
when I say I am confused I mean man I don't what to do about this clutch situation.
I came up with a decision, I am going to install my old clutchmasters fx500 pressure plate with Gripforce disc used but in good shape, untill I sell enough ---- ti raise $1200 and buy a competition trin disc fron the cron.
* 105% Clamp Increase, 415 ft/lb Torque Capacity
* Included: Pressure Plate, 6-Puck Sprung Disk, Throwout Bearing, Pilot Bearing, and Alignment Tool
* Fits 94-01 Acura Integra / 93-97 Honda Del Sol DOHC / 99-00 Honda Civic Si DOHC / 98-01 Honda Crv DOHC
#28
Re: clutch ?
ordered the competition twin disc, (xeno) hope this one will hold up, and last. been stressing the past 2 days trying to make a final decision. ---- is the most expensive single part in my setup. (bare block was around the same including S/H)