clutch ?
05-07-2008, 05:50 PM
#21
0.0 BAR
Join Date: Jun 2003
Posts: 0
Re: clutch ?
Originally Posted by rudebwoy
I think I found something that may hold up for a little bit.
http://www.-------------/catalog/stag...kit-p-158.html
http://www.-------------/catalog/stag...kit-p-158.html
* 105% Clamp Increase, 415 ft/lb Torque Capacity
* Included: Pressure Plate, 6-Puck Sprung Disk, Throwout Bearing, Pilot Bearing, and Alignment Tool
* Fits 90-91 Acura Integra
05-07-2008, 06:16 PM
#22
3.0 BAR
Thread Starter
Join Date: Mar 2003
Posts: 4,217
Re: clutch ?
that would be for a cable transmission, I have hydrolic.
when I say I am confused I mean man I don't what to do about this clutch situation.
I came up with a decision, I am going to install my old clutchmasters fx500 pressure plate with Gripforce disc used but in good shape, untill I sell enough ---- ti raise $1200 and buy a competition trin disc fron the cron.
when I say I am confused I mean man I don't what to do about this clutch situation.
I came up with a decision, I am going to install my old clutchmasters fx500 pressure plate with Gripforce disc used but in good shape, untill I sell enough ---- ti raise $1200 and buy a competition trin disc fron the cron.
05-07-2008, 07:30 PM
#23
1.5 BAR
Join Date: Feb 2008
Posts: 924
Re: clutch ?
Originally Posted by rudebwoy
I think I found something that may hold up for a little bit.
http://www.-------------/catalog/stag...kit-p-158.html
http://www.-------------/catalog/stag...kit-p-158.html
05-07-2008, 09:53 PM
#25
0.0 BAR
Join Date: Jun 2003
Posts: 0
Re: clutch ?
Originally Posted by rudebwoy
that would be for a cable transmission, I have hydrolic.
when I say I am confused I mean man I don't what to do about this clutch situation.
I came up with a decision, I am going to install my old clutchmasters fx500 pressure plate with Gripforce disc used but in good shape, untill I sell enough ---- ti raise $1200 and buy a competition trin disc fron the cron.
when I say I am confused I mean man I don't what to do about this clutch situation.
I came up with a decision, I am going to install my old clutchmasters fx500 pressure plate with Gripforce disc used but in good shape, untill I sell enough ---- ti raise $1200 and buy a competition trin disc fron the cron.
* 105% Clamp Increase, 415 ft/lb Torque Capacity
* Included: Pressure Plate, 6-Puck Sprung Disk, Throwout Bearing, Pilot Bearing, and Alignment Tool
* Fits 94-01 Acura Integra / 93-97 Honda Del Sol DOHC / 99-00 Honda Civic Si DOHC / 98-01 Honda Crv DOHC
05-21-2008, 10:31 PM
#28
3.0 BAR
Thread Starter
Join Date: Mar 2003
Posts: 4,217
Re: clutch ?
ordered the competition twin disc, (xeno) hope this one will hold up, and last. been stressing the past 2 days trying to make a final decision. ---- is the most expensive single part in my setup. (bare block was around the same including S/H)
