B/CBGC Firebird w/ .75 Garrett 412 Dart SBC
#1
B/CBGC Firebird w/ .75 Garrett 412 Dart SBC
Hello,I am building a Blown gas firebird for land speed racing using a 412 dart block w J&E pistons hellfire rings h-beams and a 4340 crank backed by a Jericho and am planning to use a .75 Garrett that was on a bus.I am planning to run the headers into a single 3" collector into the 3" inlet on the Turbo then 4" out the side in front of the pass tire with a box built around the turbo on the passenger floor,seems straight forward but I am new to the wonders of turbocharging.
If anyone has advice on wastegates and blow offs and such I would appreciate it,its going to be blowthrough carb or mechanical fuel injection cuz no computers are allowed in the classic catagory,Thanks,Chris Seifert
If anyone has advice on wastegates and blow offs and such I would appreciate it,its going to be blowthrough carb or mechanical fuel injection cuz no computers are allowed in the classic catagory,Thanks,Chris Seifert
#4
lol yeah I like that. I don't know if it would really matter what brand wastegate or bov you use. but if you are buying the wastegate I would get an adjustable one. just so much easier down the road.. does anyone know what size he might ned? like 35 38 40 :50 ect.?
#6
#7
hello and good luck boost is not hard to learn just read around a little bit this is a good sight and there is alot of knowledge on this place too..if your not a mem allready Chevy | Camaro | Firebird Reviews, Performance Parts, Modifications - LS1Tech.com
Thread
Thread Starter
Forum
Replies
Last Post
J-SMITH69
General Discussion
29
05-23-2006 12:13 AM