600 miles... is it ready for boost???
#21
Re:600 miles... is it ready for boost???
Originally Posted by Kyle
ya, just redline your ---- right away, I wonder why all your motors are blowing up?
aslong as its not a rotary you can pretty much beet on it from the get go
#22
Re:600 miles... is it ready for boost???
I didn't build my motor, I just put it in. oh wait, I did do a head gasket on it 2 times and it's still fucked, but there's not much I could do about that besides pull the block and have it decked, and that has nothing to do with ring seating or bearings or anything like that.
#23
Re:600 miles... is it ready for boost???
Originally Posted by Kyle
ya, just redline your ---- right away, I wonder why all your motors are blowing up?
you systematically push the motor to redline a few times with load to get the rings to seat. then over time drive it like you'll drive it and the rings; bearings and all the other ---- will break in as you go.
and my first motor blew because i didnt check clearnances; the rings on my new motor are going because the cylinder walls were being washed down with fuel causing them to wear prematurely.
#24
Re:600 miles... is it ready for boost???
I had the machine shop bore the cylinders out within the piston manufacturers specs... then they cut the crank, balanced it and sold me some oversized bearings... they test fit everything before i picked it up, even then i checked and double checked everything.. and everything was right on the money... so tommorow morning i put that bitch together again.
Thread
Thread Starter
Forum
Replies
Last Post
jarebear667
Turbo Parts For Sale
11
06-21-2009 08:19 PM
cjaraujo
Hybrid/Tech
4
10-24-2003 11:48 PM