CRwreckz

Looking for 4"-6" steel pipe. I want to make my own n1 style (not replica) muffler for my turbo project. I'm gonna use 3" inside, split it to punch holes/dimple then reweld it. Then make end caps. From dp back will be 3". I'm kinda a novice/amteur at welding. I just wanna make some things that I'll actually use. I already made a catch can and modified eg rails to put del sol seats in my 88. Can't be too thin though, I'm using a small 110 mig

quadnie

It's so much easier to just buy a used muffler on ebay. yeah I'm all about fabrication of my own ----, but I also do things the smart way.

Ravage70

wrong section :P

unless this was a technical question, very confused

CRwreckz

I Have the cash to go buy new, I just wanna make something myself. I have ~7g's tied up in the car so far (80% of that money is motor and management). The only things that remained the same are crank, & trans. Everything else has been replaced/ upgraded.

quadnie

if you have that much into the car, why throw on something ghetto like a homemade muffler?

Doofnoil

buy a 3" glasspack, lop it in half, flip one side over parallel to the other, weld a "loop" tothe inlet/outlets, boom n1 style muffler.

CRwreckz

I'm making the assumtion that noone could pull that kind of pipe out of their collection. I'm kinda looking to be pointed in the direction of a company that sells that size.

Ravage70

i like the boom sound

just like that chef on tv...emilio i think it is

CRwreckz

Cause it's something I made not just went out and bought, yet simple enough that I SHOULD not screw it up terribly.

quadnie

Emeril Lagasse?