i read a post but didn't quiet get the answer i was looking for, i was wondering if you connect the vaccume to the wastegate to the intake manni will it actually spool up faster or get same results as putting it to the compresor housing? some guy said it spools up faster but i was jus wondering if this tru as far as anyone else has tried it?

 

Technically it should be the same.

 

I tried it, mostly to clean things up...it didn't change spool at all on my setup...

 

only way to change it would be to install a MBC that has been designed differently then your typical ball-screw bleed valve. Look into how the hallman pro works and you will see.. there is one other MBC that does it but I can't think of the name right now.

 

well i did it and my car spools to full boost by 1200rpms' faster. problem is i'm running the BOV,FPR, and the wastegate off one vacuum source. i asked if i could put a barb in my charge pipe after the intercooler to hook up the waste gate and no answer to that but a sugestion to go for something completey different.