Turbo setup done- no boost? *WITH PIX NOW*
Ok hooked everything up finally and put a turbo basemap on my integra b18b LS and still not getting any boost read on my boost gauge. Any idea guys? I need to double check for leaks but everything seems fine. Hooked up wastegate to turbo compressor housing. Its a tial 38mm wastegate, used the side port. Helpppppppppp =P
|
Re: Turbo setup done- no boost?
Do you hear the turbo spool? Feel anything? check for leaks. Close wastegate and do a gut check.
|
Re: Turbo setup done- no boost?
where is the boost gauge connected to?
|
Re: Turbo setup done- no boost?
Listen for the turbo spooling. If you don't hear it... that's your problem.
If you hear AND don't feel it, you have a boost leak. If you hear it and feel it, your gauge/source is screwed up. Does your guage read vacuum or does it always say 0? |
Re: Turbo setup done- no boost?
pics?
|
Re: Turbo setup done- no boost?
Ill try and get pics, update right now is ive tried two gauges and when im flooring it itll go like 2 lbs of psi boost maps. All vacuum lines look good i dont see why im only getting like 2lbs of boost. not using a boost controller. 38mm tial wastegate 8psi spring
I hear turbo spooling, bov goes off so must be some pressure |
Re: Turbo setup done- no boost?
are you sure you put the fire ring in,
|
Re: Turbo setup done- no boost?
What turbo are you using?? take some pics, you are probably just overlooking something simple.
|
Re: Turbo setup done- no boost?
after saying that all i can say is boost leak bad!! make a boost leak tester and go over it, im sure thats your answer
|
Re: Turbo setup done- no boost?
is vtec enabled?
|
All times are GMT -5. The time now is 03:43 PM. |
© 2024 MH Sub I, LLC dba Internet Brands