TURBO BOOST CONTROLLER HMT style NEED IDEAS
 

I need a CHEEP boost controler real or rigged HMT style .. i dont care as long as it works.

Re: TURBO BOOST CONTROLLER HMT style NEED IDEAS
 

a ball bearing a spring and some fittings... it aint rocket science theres like 234234 writeups on it.

Re: TURBO BOOST CONTROLLER HMT style NEED IDEAS
 

i'll sell you mine.

Re: TURBO BOOST CONTROLLER HMT style NEED IDEAS
 

if your vacuum source is off the compressor, then put a vacuum T and let it vent to atmosphere. :)

Re: TURBO BOOST CONTROLLER HMT style NEED IDEAS
 

poke needle holes in the wg vaccum lines is free :1

Re: TURBO BOOST CONTROLLER HMT style NEED IDEAS
 

115 shipped for an EBC ;D

Re: TURBO BOOST CONTROLLER HMT style NEED IDEAS
 

holy ---- dude. how was the desert?

here was my old HM boost controller. it was pimped out by kevin. 100% home depot made. just a simple T with a barbed fitting on 2 ends and a bolt stickin out the top. I think there was a ball and a spring in there as well...but its pretty dam simple.
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg

Re: TURBO BOOST CONTROLLER HMT style NEED IDEAS
 

Re: TURBO BOOST CONTROLLER HMT style NEED IDEAS
 

yo sinner, you didn't even return my PM on HT about my interest in your boost controler and here you go trying to pump your ---- on this guy, who is looking for a cheap MBC. ---- off! You and your ";D" emoticon trying to look all cute.

To the original poster: if you're running low boost, a homemade spring/ ball bearing set up will work just fine. It shouldn't cost you no more than $10-12 to make from your local hardware store.

Re: TURBO BOOST CONTROLLER HMT style NEED IDEAS
 

I made an open loop EBC that uses a solenoid out of a Saab. Boost is mapped to rpm so I don't get the typical 1psi drop off up top.