for those with 14b turbos
#1
for those with 14b turbos
have you taken it apart before? if so, im in need of some help. i took mine apart a month or 2 ago and now when i put it back together i dont remember... the center cention and exhaust side where the clamp goes. was there a gap inbetween those? like the thickness of a dime... or are they supposed to fit flush together?
i can't seem to get it to fit flush, so i only assume there is supposed to be a gap there.
any help would be great, thanks
i can't seem to get it to fit flush, so i only assume there is supposed to be a gap there.
any help would be great, thanks
#2
Re:for those with 14b turbos
there is a pin that needs to be lined up on the exhaust side. it should fit flush then u put the ring on and tighten the locking nut on the clamp.
on the cold side have fun with that snap ring. pain in the ***!
this is what i do to get that snap ring on, i grinded some needle nose to fit the holes, then put the ring in my vice compressed it alot, put the neelde nose in. pulled it out and put it in the turbo.
watch out cause if that ring comes off itll hurt like a ----- if it hits you.
good luck.
on the cold side have fun with that snap ring. pain in the ***!
this is what i do to get that snap ring on, i grinded some needle nose to fit the holes, then put the ring in my vice compressed it alot, put the neelde nose in. pulled it out and put it in the turbo.
watch out cause if that ring comes off itll hurt like a ----- if it hits you.
good luck.
#3
#4
Re:for those with 14b turbos
Originally Posted by shortyz
there is a pin that needs to be lined up on the exhaust side. it should fit flush then u put the ring on and tighten the locking nut on the clamp.
Thread
Thread Starter
Forum
Replies
Last Post
WTF
General Discussion
15
03-04-2007 12:39 AM
B16Drag
General Discussion
4
03-12-2006 02:13 PM
Alex in Houston
Turbo Parts For Sale
4
03-20-2004 11:26 AM