T3 .48/.60 spool up on stock B16A
My setup is a SSAC 38mm wg with 6psi spring. dual stage turbo xs manual controller. greddy type s bov, home made short tubular manifold. FMIC 5X2.5X15 (core size). Stock engine tuned for 12 psi high boost and running 8 psi daily (low boost).
It starts to get into boost at about 3K rpm and get to full boost by about 3400. Is this normal for the .48/.60? if i'm cruisin on the interstate at about 80mph (~4000rpm) it takes a couple seconds to build full boost. Is this normal, or do I have a boost leak somewhere? |
Re: T3 .48/.60 spool up on stock B16A
My call: boost or exhaust leak somewhere.
The B16A can make a 0.48/0.60 T3 completely by 3000 RPM. That means: at 4000 RPM, if you floor it, it should kick-in instantly. A 125$ preventive rebuild on your t3 60 trim could re-assure you on it's performances and reliability. |
Re: T3 .48/.60 spool up on stock B16A
do you hear any exhaust leak sound around the turbo/manifold/wg? i think that's about normal. u mite be gettin pressure drop in ur 5 inch ic?? not all setups are the same n not all setups are gonna get full boost at the same rpm. check for leaks everywhere. couplers/motor to manifold, manifold to turbo etc... check everything. maybe ur ssautopoop wg isn't closed all the way causing a lil lag on creating boost?
|
Re: T3 .48/.60 spool up on stock B16A
boost should be INSTANT on the freeway. the times when the turbo spools up and reaches full spool is just slightly later than mine. but I would make sure that its not leaking anywhere. just double check everything.
|
Re: T3 .48/.60 spool up on stock B16A
on the highway, it does boost instantly but it takes a couple seconds to get to full boost. It jumps to like 3psi instantly and builds from there. When I get some free time I will check all of my couplers.
I dont have any exhaust leaks before the turbo. And teh only hissing sounds I can hear are frmo my BOV sucking in air at idle. Where can I get this rebuild kit? I know the seals are bad in the compressor. Not terrible, but they are letting a little oil get by. |
Re: T3 .48/.60 spool up on stock B16A
I bought a rebuild kit off ebay
|
Re: T3 .48/.60 spool up on stock B16A
boost on the freeway should be almost instant to full boost. i get 15psi instantly after getting on it "trying" to boost.
|
Re: T3 .48/.60 spool up on stock B16A
Originally Posted by turboDA6
boost on the freeway should be almost instant to full boost. i get 15psi instantly after getting on it "trying" to boost.
|
Re: T3 .48/.60 spool up on stock B16A
i have a .63/.60 on a d series and my ---- spools that at 3500. but i also have a straight pipe from the turbo outlet to the rear of the car.
|
Re: T3 .48/.60 spool up on stock B16A
My b16 and t3 .48/60 setup i reach 7psi at about 4,200rpm. I think i got some issues. I am running 21/4 exaust that is bent and dinged. And i need to tune it more.
|
All times are GMT -5. The time now is 06:37 AM. |
© 2024 MH Sub I, LLC dba Internet Brands