Supporting a PWR barrel?
Thread Starter
0.0 BAR
Joined: Jan 2003
Posts: 26
Supporting a PWR barrel?
I have the smaller PWR air to water IC.
The long run of IC piping with the IC in it is "sagging" due to weight, it will be worse when the system has fluid in it. I'm thinking of fabricating a cradle to support the IC.
Anyone have any pics of something like this? I'm thinking a half moon of 1" wide 1/8" steel with a rubber insulator, weld on a small post, and bolt this to the tranny.
Thanks.
The long run of IC piping with the IC in it is "sagging" due to weight, it will be worse when the system has fluid in it. I'm thinking of fabricating a cradle to support the IC.
Anyone have any pics of something like this? I'm thinking a half moon of 1" wide 1/8" steel with a rubber insulator, weld on a small post, and bolt this to the tranny.
Thanks.
Thread Starter
0.0 BAR
Joined: Jan 2003
Posts: 26
Re: Supporting a PWR barrel?
The section of piping it is in runs along the side of the engine from just in front of the radiator to the throttle body ( past the distributor).
This is a d16a6 CRX, no battery under hood.
This is a d16a6 CRX, no battery under hood.
Thread
Thread Starter
Forum
Replies
Last Post
stenseltizm
Turbo Parts For Sale
11
Sep 21, 2008 11:49 PM
Jays91DXhatch
Turbo Parts For Sale
25
Aug 2, 2005 01:53 AM
