Supporting a PWR barrel?
 

I have the smaller PWR air to water IC.

The long run of IC piping with the IC in it is "sagging" due to weight, it will be worse when the system has fluid in it. I'm thinking of fabricating a cradle to support the IC.

Anyone have any pics of something like this? I'm thinking a half moon of 1" wide 1/8" steel with a rubber insulator, weld on a small post, and bolt this to the tranny.

Thanks.

Re: Supporting a PWR barrel?
 

Where are you putting it at.

Re: Supporting a PWR barrel?
 

The section of piping it is in runs along the side of the engine from just in front of the radiator to the throttle body ( past the distributor).

This is a d16a6 CRX, no battery under hood.