JDMFantasy2K

How many of you guys are running stainless steel drain line? I'd like to go stainless on my new motor and i was wondering what size hoese are you guys using, and where'd you get them from. I know you need at least 1/2 diameter, but some of this -AN stuff confuses me a bit. What is a good size? -10AN? Also, how do you cut and add fittings to the hose?

CRXDrew

Pretty sure -10 is 5/8 inch.

I've used both -10 SS and both 5/8 and 3/4 heavy duty rubber hose with success.

ChevyIIMan

Im running -8an SS lines. Honestly anything over 1/2in(-8an) will work.

iceracercrx

Every time you see AN lines they are all called - something. Just to clear something up I will let you guys in.

-x/16 of a inch

-3 = 3/16 of a inch
-16 = 16/16 of a inch
-8 = 8/16 or 1/2

CRXDrew

hmm.. cool. thanks for that info.

JDMFantasy2K

that is possibly the most useful piece of info i've seen on hmt since everyone found out hotrex had herpes Someone get that table in a sticky, good for newbs too.

irocz

To cut the ss lines you need an angle grinder with a cutoff wheel on it. Then tape the part you are cutting with duct tape.

JDMFantasy2K

how do you get a new fitting on it after you cut it?