SS oil drain line
How many of you guys are running stainless steel drain line? I'd like to go stainless on my new motor and i was wondering what size hoese are you guys using, and where'd you get them from. I know you need at least 1/2 diameter, but some of this -AN stuff confuses me a bit. What is a good size? -10AN? Also, how do you cut and add fittings to the hose?
|
Re: SS oil drain line
Everybody running Stealthmode's kit is using a braided stainless line. -10
|
Re: SS oil drain line
Pretty sure -10 is 5/8 inch.
I've used both -10 SS and both 5/8 and 3/4 heavy duty rubber hose with success. |
Re: SS oil drain line
Im running -8an SS lines. Honestly anything over 1/2in(-8an) will work.
|
Re: SS oil drain line
Every time you see AN lines they are all called - something. Just to clear something up I will let you guys in.
-x/16 of a inch -3 = 3/16 of a inch -16 = 16/16 of a inch -8 = 8/16 or 1/2 |
Re: SS oil drain line
Originally Posted by iceracercrx
Every time you see AN lines they are all called - something. Just to clear something up I will let you guys in.
-x/16 of a inch -3 = 3/16 of a inch -16 = 16/16 of a inch -8 = 8/16 or 1/2 |
Re: SS oil drain line
that is possibly the most useful piece of info i've seen on hmt since everyone found out hotrex had herpes :y Someone get that table in a sticky, good for newbs too.
|
Re: SS oil drain line
To cut the ss lines you need an angle grinder with a cutoff wheel on it. Then tape the part you are cutting with duct tape.
|
Re: SS oil drain line
Or just a dremel
|
Re: SS oil drain line
how do you get a new fitting on it after you cut it?
|
All times are GMT -5. The time now is 07:19 PM. |
© 2024 MH Sub I, LLC dba Internet Brands