Some Newbie Questions With Porn!!!
Thread Starter
0.5 BAR
Joined: Oct 2006
Posts: 57
Some Newbie Questions With ****!!!
Im planning on installing my HMT kit this weekend if my intercooler piping comes in from racing sloutions.So i have a couple of questions that i havent figured out yet.here is my setup.And some ****!
90 honda crx si
d16y8 (head) minime
hf manifold
14b adapter plate
dsm 450cc
fmic
xenocron basemap
1. I have a crx si with a resistor box.My question is when installing the dsm 450cc injectors do i need to modify the wiring or anything?
2. I need some couplers for my intercooler piping any suggestions? example Can i just use radiator piping to put them together or is there something better i can use around town?
3. I also need to figure out where to connect my vacuum lines from my wastegate and bov.Also does napa have these vacuum lines?
90 honda crx si
d16y8 (head) minime
hf manifold
14b adapter plate
dsm 450cc
fmic
xenocron basemap
1. I have a crx si with a resistor box.My question is when installing the dsm 450cc injectors do i need to modify the wiring or anything?
2. I need some couplers for my intercooler piping any suggestions? example Can i just use radiator piping to put them together or is there something better i can use around town?
3. I also need to figure out where to connect my vacuum lines from my wastegate and bov.Also does napa have these vacuum lines?
0.0 BAR
Joined: Nov 2003
Posts: 0
Re: Some Newbie Questions With ****!!!
Originally Posted by sexymangsxr
1. I have a crx si with a resistor box.My question is when installing the dsm 450cc injectors do i need to modify the wiring or anything? mod the lower seal
2. I need some couplers for my intercooler piping any suggestions? example Can i just use radiator piping to put them together ? yes for now
3..Also does napa have these vacuum lines? yes
good job on the ****
3.0 BAR
Joined: Aug 2003
Posts: 4,664
From: NE-PA
Re: Some Newbie Questions With ****!!!
Ok, the **** was a failure, but I'll help you out anyway :P
1. No wiring mods needed to use the dsm 450's on your si.
2. For ghetto cheap couplers try using Home Depot fernco couplers...you can find them in the plumbing section in various sizes and even come with band clamps. Would not suggest running them over 12 psi though, they will start to pop off.
3. You can connect your wastegate line to either a spot on the intake manifold, or to the outlet on the compressor. The bov needs a vacuum source only, so hook it to the intake manifold.
1. No wiring mods needed to use the dsm 450's on your si.
2. For ghetto cheap couplers try using Home Depot fernco couplers...you can find them in the plumbing section in various sizes and even come with band clamps. Would not suggest running them over 12 psi though, they will start to pop off.
3. You can connect your wastegate line to either a spot on the intake manifold, or to the outlet on the compressor. The bov needs a vacuum source only, so hook it to the intake manifold.
Thread
Thread Starter
Forum
Replies
Last Post
