Remove the Housing off of a T25 turbo
#1
Remove the Housing off of a T25 turbo
Does anyone know how to remove the housing for the air pump and exhaust off of a T25 turbo? I wanted to get the center out so I could replace the bearings. I lossed all the bolts and tried to bang on it with a hammer but nothing happened.
#2
Re:Remove the Housing off of a T25 turbo
if you got all the bolts off give it a few taps with a hammer while kinda holding the whole turbo in the air.
do this over a bench u dont wanna break the exhaust housing..
just keep working on it. like tap one side then the other.
do this over a bench u dont wanna break the exhaust housing..
just keep working on it. like tap one side then the other.
#4
Re:Remove the Housing off of a T25 turbo
I used a blowtorch when pulling mine apart... the trick is, to heat the ---- out of the exhaust housing without heating the "cartridge" in the center...
then after it's nice & hot as hell, a couple light hammer taps should seperate it...
installation is reverse of removal ;-)
-Henry
then after it's nice & hot as hell, a couple light hammer taps should seperate it...
installation is reverse of removal ;-)
-Henry
#5
Re:Remove the Housing off of a T25 turbo
I have never had to use a blow torch to remove the center section, put the exhaust housing in a vise, (remove the ring/bolts) and use a hammer to hit the backside of the compresor, be sure to not let it hit the ground though
Jeff
Jeff
Thread
Thread Starter
Forum
Replies
Last Post
crx2211
Wanted
2
12-24-2008 08:33 AM
90turboteg
Turbo Parts For Sale
2
01-29-2005 11:54 AM
krskid
Wanted
6
08-02-2004 08:18 PM