Remove the Housing off of a T25 turbo
Does anyone know how to remove the housing for the air pump and exhaust off of a T25 turbo? I wanted to get the center out so I could replace the bearings. I lossed all the bolts and tried to bang on it with a hammer but nothing happened.
|
Re:Remove the Housing off of a T25 turbo
if you got all the bolts off give it a few taps with a hammer while kinda holding the whole turbo in the air.
do this over a bench u dont wanna break the exhaust housing.. just keep working on it. like tap one side then the other. |
Re:Remove the Housing off of a T25 turbo
Lots and lots of liquid wrench or PB blaster will help also... If it gets extreme, you could try a blowtorch (?)
good luck |
Re:Remove the Housing off of a T25 turbo
I used a blowtorch when pulling mine apart... the trick is, to heat the ---- out of the exhaust housing without heating the "cartridge" in the center...
then after it's nice & hot as hell, a couple light hammer taps should seperate it... installation is reverse of removal ;-) -Henry |
Re:Remove the Housing off of a T25 turbo
I have never had to use a blow torch to remove the center section, put the exhaust housing in a vise, (remove the ring/bolts) and use a hammer to hit the backside of the compresor, be sure to not let it hit the ground though ::)
Jeff |
Re:Remove the Housing off of a T25 turbo
I got the exhaust housing off but what about the air pump, the same way? Just hammer it off.
|
Re:Remove the Housing off of a T25 turbo
on a mitsu T25 (from a 96 up talon/eclipse) a big snap ring holds the cold side on, so you'll need a large snap ring plier.
|
All times are GMT -5. The time now is 03:47 AM. |
© 2024 MH Sub I, LLC dba Internet Brands