Project Beater Officially Done - Almost..... (New Snail and other parts added)
#12
Re: Project Beater Officially Done - Almost.....
They actaully came on a lot of Sabb's. Volvo's and a variety of Porches. I found a web page a while back that had all of the part numbers of all the various spring rates etc...
#16
Re: Project Beater Officially Done - Almost.....
My new snail arrived finally after a month of waiting. I also have a cutout and flex to install. Driving around with and open downpipe was fun for about the first 5 minutes but because very annoying after that. I have started bumper reconstruction. I am reworking the bumper surrounding the intercooler itself so that it will sit flush all around the intercooler and so it will fit the car decdently. It is hagning on with zip-ties at the moment because the local law officials think that I need my bumper to operate my vehicle. I am also reshaping the lower part of the bumper to have slight bump-outs where the chargepipes run behind. Lots of fiberglass is being used and the results should be great. I will post pics up once it is done.
#17
Re: Project Beater Officially Done - Almost..... (New Snail and other parts adde
you may want to place your o2 sensor further away from the turbo. I got bad readings on my wideband when mine was placed too close. Other than that the setup looks sick
#18
Re: Project Beater Officially Done - Almost.....
Originally Posted by beater
They actaully came on a lot of Sabb's. Volvo's and a variety of Porches. I found a web page a while back that had all of the part numbers of all the various spring rates etc...
Thread
Thread Starter
Forum
Replies
Last Post
RotaryGeek
General Discussion
112
07-05-2008 03:06 PM
airtonics
General Discussion
31
12-16-2003 09:40 PM
ReignOfChaos
Forced Induction
5
08-29-2003 10:31 PM