Re:Pic **Custom Manifold** almost completed
 

here's a Q, did you have to "squish" the pipes at all to match the ovals of the flange?

-H

Re:Pic **Custom Manifold** almost completed
 

they are really hard to do but its do-able.

u gotta stay on it with a torch for like 10 min then take a big sledge to the ends. make sure u hit it i the right spot or your piece could be garbage..
i port matched mine pretty good that way.. only took an hour.

Re:Pic **Custom Manifold** almost completed
 

"u gotta stay on it with a torch for like 10 min then take a big sledge to the ends. make sure u hit it i the right spot or your piece could be garbage.."

when i made the fullrace knockoff i just put the pieces in a big bench vice and it ovaled out quite nice with out heat.

Beau

Re:Pic **Custom Manifold** almost completed
 

heres my manifold

http://images.cardomain.com/installs...8_105_full.jpg

Re:Pic **Custom Manifold** almost completed
 

HEre's a question.. if the pips are actually more round, and the port ont he flange actually smaller diameter than the pipe, would it matter if it were "squished" or not?

Re:Pic **Custom Manifold** almost completed
 

how big was that vice. holy ----! i couldnt even move mine 1 bit..

Re:Pic **Custom Manifold** almost completed
 

um bigger than a bread box ;)

Beau

Re:Pic **Custom Manifold** almost completed
 

Looking nice but isnt that flange a bit thin? 6 or 8mm rigth?

i used 10mm thick iron on this:
http://home.online.no/~arban/Pics/Headers9.jpg

as an alternative i have also bougth a manifold from a different car with a tubular mild steel manifold wich i am in progress with modyfying for fitting my engine and the turbocharger.
This one has a 12mm thick flange.
http://home.online.no/~arban/Pics/FS%20mani3.jpg
pic shows the manifold in untouched condition.

Re:Pic **Custom Manifold** almost completed
 

even though this post is old, i was wondering if you or anyone else could build me this manifold, preferably for under $125. the only place around here that sells those pieces wants way too much for them.

Re:Pic **Custom Manifold** almost completed
 

Since the ends of the pipe were too hard to smash to make them oval I tacked the pipe to the flange then I had to fill the inside of the flange (head side) with welds. I then ported the welds again to smooth the transition between the oval(flange) and the weld els(pipe).

http://community.webshots.com/script...bumID=73923652