Re: Oil Supply for Holset
 

I run -4an line, no restrictor. HY35 off an 01 Cummins

Re: Oil Supply for Holset
 

Tits, Ordering it now

Re: Oil Supply for Holset
 

I got my o-ring fitting from a hydrolic shop. $4 or so for my entire oil line setup.

Re: Oil Supply for Holset
 

The HE351VE that I have has a completely different size than the HX40 that I had before. You should verify that it fits the HE351VE before you order it. IIRC it was quite a bit bigger than the HX40 oil fitting.

Re: Oil Supply for Holset
 

Ok well i guess I don't need to check then.
I hope it works out for you.

Re: Oil Supply for Holset
 

Got distracted and didn't get it ordered yet. I have one of those right now but it goes to -6. Think I will order the -3 so I dont need to get new oil lines.

http://www.thezcr.com/gallery/data/5...m/100_2425.JPG

http://www.thezcr.com/gallery/data/5...m/100_2426.JPG

And just for the hell of it

http://www.thezcr.com/gallery/data/5...m/100_2428.JPG

Re: Oil Supply for Holset
 

^^^^damn that thing is a monster

Re: Oil Supply for Holset
 

I couldn't remember if it was the right thread type.
Good luck.
D SERIES POWA!

Re: Oil Supply for Holset
 

My holset came without the stock inverted flare fitting that people thread the m12x1.25 fitting into. I had to use a gas tank coupler and tap the inside to m12x1.25 and used that. Then I drilled out the fitting and tapped it for a set screw with a 1/16th hole in it.