What kind of fitting are you guys using on the oil pan? I'm trying to figure out what stuff I'll need and so far I've came up with this. Correct me if any of this is wrong, because im really confusused. I just basically copied setups on the site. The setup is a 14b on a d16y7, with z6 intake manifold, and gsr tb. Thanks in advance.

350psi 1/4 hose
2 brass T (any special size??)
5/16 fuel line
1/4 brass fitting
1/8npt brass extension to 3 way splitter
1/8npt brass barb

 

Use one as big as possible, make sure the mounting on the pan is above the oil level.

 

Just use a brass fitting and weld it on?

 

hole in block is 1/8 bspt
aftermarket oil press sender is ussually 1/8 npt.
i use 8 an bulk head connector on oil pan