Hey i started up my civic for the first time in 8 months and i have a bad leak with my oil feed line... could be cuz i didn't use any type of sealant but will some Thread lock and silicone sealant work for this?? need to know asap!!!!!!!!

 

I have the same problem. If it's the block fitting just use teflon tape. Unless your threads are totally fucked and cross threaded this should work.

 

dont use thread lock.. just use some teflon. white stuff..

 

My threads were fucked on my block! so i used teflon and it still leaked so i used JB WELD! No more leaks! i just hope it never needs to come off again!

 

well i used HIGH TEMP thread lock *AND* white silicon with teflon... hehe.. worse comes to worse JB WELD TIME!!!!

 

also i didn't realize it but for a few seconds i was running a tad over 2 quarts in there.... i didn't know i was loosing any oil, good thing i caught it when i did

 

hey guys i lost the package that these came in.. how long should i wait till i can test the strength of the thread lock and sealant out? overnight?

 

if you want to be really sure wait at least 24+ hours

 

i use loctite. never had a problem with it. only takes a couple minutes to dry. never leaked for me. used it for a lot of ----. oh and TMR(big *** shop that sells earl's fittings and all kinds of ---- in so cal) doesnt recommend teflon tape because it ***** up the threads

 

well the lock thread and sealant blowed ***.. so i JB welded it