New manifold and cant contol boost????
03-21-2006, 01:15 PM
#21
0.5 BAR
Thread Starter
Join Date: Aug 2005
Posts: 156
Re: New manifold and cant contol boost????
Originally Posted by splitime
130 is below 8.5:1 ... did you have the pedal to the floor while doing the test? And honestly, if the numbers are all close to each other, I wouldn't worry much.
Really though, when your WG opens... things should drop. Is that Line to the WG that I see coming right off the compressor housing? and going to the correct port on the WG? Its not run to the top port and holding the WG closed is it?
That gate also looks like a DeltaGate?(aka: deltacreep)... they seem to have boost controlling issues on some peoples setups.
Really though, when your WG opens... things should drop. Is that Line to the WG that I see coming right off the compressor housing? and going to the correct port on the WG? Its not run to the top port and holding the WG closed is it?
That gate also looks like a DeltaGate?(aka: deltacreep)... they seem to have boost controlling issues on some peoples setups.
pedal to the floor
I must have done somthing wrong.yeah i have heard about the delta creeps I will be upgrading soon.
That line is going into the side of the wastegate from a boost controller and out to the side of the compressor housing.
03-21-2006, 01:50 PM
#22
1.0 BAR
Join Date: Apr 2004
Posts: 240
Re: New manifold and cant contol boost????
Try running from the Comp housing straight into the WG, try to rule out the boost controller as the problem.
When you do the compression test,
pull the ecu fuse
pull all sparkplugs
Put comp tester into a cylinder
when you crank it, put the pedal to the floor (WOT)
... repeat steps 3 and 4.
When you do the compression test,
pull the ecu fuse
pull all sparkplugs
Put comp tester into a cylinder
when you crank it, put the pedal to the floor (WOT)
... repeat steps 3 and 4.
Thread
Thread Starter
Forum
Replies
Last Post
crx4life2003
Forced Induction
1
06-16-2004 07:53 PM
