draztik

Okay i switched the sensor code on the V-AFC from 06 in and 06 out... i switched it to 0 in and 0 out.. and no CEL and it idles perfect.... how did that work?

projekteg

are all the other sensor types on the afc set at '0'?? are you sure you're setting the right sensor type (i believe it's 'pressure', i haven't looked at an afc in a while).

draztik

on the AFC its says Sensor Type and the book says 06 in 06 out..... it runs better at 0 in 0 out..... but i still throw the CEL everyonce and a while and my ecu blinks #3 all the time...... MAP Sensor.... WTF do i do? should i just run a check valve on the map sensor or what the ---- should i do?

projekteg

s-afc or v-afc?

draztik

V-AFC

draztik

OMFG!!!!!!!!!!! someone shoot me in the forehead!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! MOTHER ******! AHHHHHHHHHHHH.. ok the Pressure wires from the V-AFC i never had connected, i disconnected them so i couldn't mess with them when i did the mini-me swap... i was going to get it dyno tuned but then blew my headgasket and thats when the car went up on stands...

well anyway what ECU code thing do i go by on www.apexi.com they don't have PM6 88-91 civic/crx si ecu!!!! please help me...

also theres 2 wires... which one goes where: the YELLOW one says Pressure OUTPUT and the WHITE wire is Pressure INPUT... should i cut that wire and connect the pressure wire running to the map sensor to the white one (INPUT) and then the yellow one back to the wire from the ecu? please help.. thank god i saw that when i did... i've only driven it 2 times around my block..