lookin for T3
#1
lookin for T3
hey.. i'm startin to purchase parts for my setup and i'm lookin for a T3 .42/.48.. do these come stock on any cars? if not then what's a nice equilevent(sp?) for Y8? not lookin for dyno queen... just.. faster..
#2
Re:lookin for T3
t3 .42/.48 came on a few mopars, crysler lebaron and similar cars, but that flange was uber gay, I have one, it sucked to make the flange work. they also come on most saabs, and I think there may have been some on volvos as well, I'm not sure on that one though.
#5
Re:lookin for T3
re-drilling is a bitch on a flange. after an hour of drilling, and 2 bits, i still managed to drill it crooked. weld it to a adaptor plate and be done with it.
I welded the turbo to an adaptor plate, then bolted the adaptor plate to the manifold.
I welded the turbo to an adaptor plate, then bolted the adaptor plate to the manifold.
#7
Re:lookin for T3
A drill press will help you keep from drilling the hole crooked. Just be sure and do the following:
--Use good bits
--Use a cutting oil of some sort
--start with a small bit and move up
--Keep your bits cool
--measure it. don't just eyeball it.
--be patient
--Use good bits
--Use a cutting oil of some sort
--start with a small bit and move up
--Keep your bits cool
--measure it. don't just eyeball it.
--be patient
Thread
Thread Starter
Forum
Replies
Last Post
turbohf
Engine Management
10
10-30-2003 12:46 AM