Sirex

well i got 8 Ubends four from turbopiping and four from jcwhitney, 2.25 inch diamters... i dont wanna relocate my battery... how can i make the pipe for the passenger side?

also, could i seal the breather on the cold air intake i have and weld on the flange for the bov on there? and use that instead?


Please post pics if you have any... thnx

turbocrxb18

just face the facts and move your damm battery, i did and everyone else with that setup has. For the cables, box, and a new battery from autozone it ran me like 50-60 bucks and took me 30 minutes to install. plus once it's gone it gives you plenty of room to mount and MSD box and coil.

Dr.Boost

With 8 u bends you should be able to work around anything. I guess I am not too familiar with the rex engine bay. I would want to keep the battery up front for traction purposes.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

Semnos

Take the route the stock air intake makes...It will required sum cutting

Sirex

ttt

Dr.Boost

Just found this one thread down.

__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

RENR

wow , is that about 9 clamps that i see in that lil section of piping?

Sirex

umm ok dr boost.. i have mandrel bends..
thats such a nigg rigged *** setup in that pic..
thats horrible.. i would never do that to my car..
that makes baby jesus cry..

projekteg

ha! is that a screwdriver hanging off of the dizzy