install came to a little hault....few questions
just put my t3 kkk mercedez turbo on my b20
injectors and oil lines went on last weekend, wanted to start it up with out the piping on to make sure the injectors work before i put the fuel pump in so if it didnt start i would know what have caused it not having to guess between the two, i think the turbo seals are shot or my drain sucks, im using 5/16 hose...way to small? using an oil restrictor too also i have always got the solid check engine light when using crome or uberdata....hooked up my wideband when it was all motor and checked out...still have no clue on that one and yes i removed the checksum in crome. |
Re: install came to a little hault....few questions
4 Attachment(s)
|
Re: install came to a little hault....few questions
5/16" for the drain? I think that's a bit small. I typically use 1/2 to 5/8" for the drain. If that doesn't fix it then you're looking at a rebuild.
As for the engine light, is it pulling a code at all? Have you verified that your ECU works in another car? Who chipped it? |
Re: install came to a little hault....few questions
yea it worked in my car before i chipped it, no codes i have a toggle switch so i dont have to see the solid cell so when its flipped it would blink if there was a code
the two pins in the green harness with a cable got real old when i was getting the codes off my d16 |
Re: install came to a little hault....few questions
How are you burning the chips? Burn1?
|
Re: install came to a little hault....few questions
yes sir
|
Re: install came to a little hault....few questions
Post your bin that you are useing for we can take a look at it.
|
Re: install came to a little hault....few questions
how open is your restrictor
|
Re: install came to a little hault....few questions
around 60 thou i think im about to pull it off and check but its raining out and i dont have a garage... so im getting wet
its not so much one bin giving me the trouble, i have messed around with different programs for awhile, everything works ok(launch control, vtec point, sensors turn on/off, etc) except i couldnt get uberdata to datalog, was dataloging my wideband right to my computer, but i still get the constant cel, who would like to be emailed my bin its off xenocron's site but for 460cc injectors thanks for the help so far, makes the learning curve a little easier |
Re: install came to a little hault....few questions
I will make you a bin. But this is what i need to know
1.what ECU do you have 2. what size injectors are you useing 3.what map sensor are you useing |
All times are GMT -5. The time now is 04:43 AM. |
© 2024 MH Sub I, LLC dba Internet Brands