Inlet neck and outlet flange
#1
Inlet neck and outlet flange
I have a T3 .60/.63, on the inlet it doesn't have a neck like most turbos, it has 45 degree neck that can be removed and has two vacuum line fittings on it. Should I use this neck or do I need a straight one?
Where can I find a T3 charge outlet flange and how do you guys go about stepping the pipe up to 2.5".
By the way I got my Tyrus IC today and it is soooo hot.
Where can I find a T3 charge outlet flange and how do you guys go about stepping the pipe up to 2.5".
By the way I got my Tyrus IC today and it is soooo hot.
#2
Re:Inlet neck and outlet flange
if you have 1 neck already just cut it down and use a silicone connector.
u can goto 2.5 with an ABS pipe fitting from home depot they are black soft rubber.
look on ebay for that other neck, or make one.,
good luck with the tyrus
u can goto 2.5 with an ABS pipe fitting from home depot they are black soft rubber.
look on ebay for that other neck, or make one.,
good luck with the tyrus
Thread
Thread Starter
Forum
Replies
Last Post
stillnoturbo
Turbo Parts For Sale
0
09-03-2005 09:50 PM
david_jones001
Turbo Parts For Sale
1
05-10-2005 08:22 AM