I ran out of vacume sources, could i create one from the charge pipe?**PICS**
#31
Re:I ran out of vacume sources, could i create one from the charge pipe?
Originally Posted by trebor_nordap
that thing's $45. on ebay. i think i'll jb weld a plastic barb to the charge pipe and paint the CP and barb chrome color. aslong as it works. i'll make sure it looks acceptible. thanks though i never knew that golden eagle thing existed.
#32
Re:I ran out of vacume sources, could i create one from the charge pipe?
Originally Posted by trebor_nordap
that thing's $45. on ebay. i think i'll jb weld a plastic barb to the charge pipe and paint the CP and barb chrome color. aslong as it works. i'll make sure it looks acceptible. thanks though i never knew that golden eagle thing existed.
As far as sccaeg's piece, something like that would work, but claiming it only cost 5 dollars is bs when it's obvious you have about 3 packs of jb weld on that thing
#34
Re:I ran out of vacume sources, could i create one from the charge pipe?**PICS**
i think scaaeg used more jb weld then neccesary. less jb weld on the edges would've worked just as good. that thing scaeeg built won't see more than 15psi in it's lifetime. that's nothing for jb weld.
#35
Re:I ran out of vacume sources, could i create one from the charge pipe?**PICS**
well, it held an air compressor pushin about 60psi going through it. thats how I know it worked.
and use to much JB weld. I didnt know you could do such a thing....
JB weld is my friend. <--i like this smiley.
and use to much JB weld. I didnt know you could do such a thing....
JB weld is my friend. <--i like this smiley.
#37
Re:I ran out of vacume sources, could i create one from the charge pipe?**PICS**
man for 5$ u could have take a piece of 1" sqaure bar drilled the middle out, and drilled 5 holes on the side, tapped those with a 1/8 npt or 1/4 npt and stuck some barbs in.
that ---- is ghetto, u might wanna flare the end so it doesnt pop off
that ---- is ghetto, u might wanna flare the end so it doesnt pop off
#38
Re:I ran out of vacume sources, could i create one from the charge pipe?**PICS**
Originally Posted by shortyz
man for 5$ u could have take a piece of 1" sqaure bar drilled the middle out, and drilled 5 holes on the side, tapped those with a 1/8 npt or 1/4 npt and stuck some barbs in.
Thread
Thread Starter
Forum
Replies
Last Post
HMT-Roger
General Discussion
0
09-25-2011 12:40 PM
AzntaggeR
Forced Induction
3
04-12-2005 02:41 AM