D16Y8-Z6

Seriously.
What would be the outcome.
Id be running 10 psi.
Am I even going to be in the turbo's range to make power at 10 psi ?
Im still running a 42/48. And its decent but im Bored.

I dont care if it doesnt spool till 5k. If that, fine, anything after that is iffy.
From what Ive read this is one of the smaller holsets.

Any input would be cool.
If not go ------- kill yourself =)

samson

What about a super 60 instead?


JP

D16Y8-Z6

What about a Holset for 50 bucks.

samson

Never mentioned the Holset for that price. I don't know man. Up to you I guess.


JP

hotrex

thts pretty big, it will be laggy for sure, but top end will be retarded.

samson doesnt know wtf hes talking about, he mom still breastfeeds him.

give it a shot. im sure youll like it. does it have the split entry housing??

Racintweek

the compressor will be more than enough at 10 PSi to blow a non forged SOHC. you should look for a smaller turbine housing if you want to see boost before the rev-limiter kicks in.

D16Y8-Z6

No split entry =\.

Ive got a stock motor for now.
I could see it putting a hole in my block on a d15/d16.
But im comp. is super low so I think I might be alright.

Thanks for the replies.
Im prob gonna pick it up today.

Racintweek

with the non split housing i believe it is either a 9 or 12cm2. if iti is a 12 you will have a very short high RPM powerband

D16Y8-Z6

If it ends up being to bigo for my sohc ill put it on my bros GSR.
Where it belongs lol.

But I want it damn it.
If my power band is 5500-8k ill be ok.

Racintweek

i'd go ahead and get it, its a good deal and even if you dont use it you can sell it on HT for 16 bazillion dollars