Re:homemade boost controler? how to?
 

that would work too...
ALthough i know for a face the way i said it will work..
You think the air wont make a rigt turn? Air will find the fastest way out. And if that valve is closer than the wastegate it will leak air...
This is the setup i have run on my srt4 and not only did it work, But the turbo spooled up noticably faster too..

Re:homemade boost controler? how to?
 

that's the most unreliable thing i've ever heard, you may as well just poke holes in your wg line, that would be even easier and would be just as safe/reliable as whay you say :P

Re:homemade boost controler? how to?
 

neither of this ---- works

if you put an adjustable valve inline you restrict the folw in both directions so when you lift off the throttle and then floor it again your wg will be open and you will boost slow as ----.

if you want to use the T piece then you should cut the pipe from the snail to the wg, and then insert the T and put the pipe to the wg adjacent to the pressure line from the turbo and then put the valve on the unused part of the fitting

Re:homemade boost controler? how to?
 

refer to the first link i posted for a home made boost controller..... the end!

Re:homemade boost controler? how to?
 

Actually this would work. It is equivalent to "poking holes in the hose feeding the wastegate". It just allows you to adjust the size of the hole via an adjustable valve.

Re:homemade boost controler? how to?
 

now that he explained it a little better, i know that it will work, but it's unreliable and then what, you have a vacuum leak also. just go out and spend 10 bucks for the parts to make a ball spring wg if anything.

Re:homemade boost controler? how to?
 

Werd
And how is this unreliable? I dont see how so?

Re:homemade boost controler? how to?
 

if this was a safe, reliable way to raise boost, don't you think everyone would do it? everyone knows that poking holes in your wg signal line will raise boost (which is essentially the same thing that you bring to the table), yet do you see anyone doing it? not really ;)

Re:homemade boost controler? how to?
 

except i provide a adjustable way of doing it and also a reversble way.. I dont have to cause permanent damage tow astegate hoses...
My way is the way all the DSM / srt4 guys do it..

Re:homemade boost controler? how to?
 

You wont have a vaccum leak because the input boost source is from the compressor and not from the manifold. The Bleed type valve does work, thats what Vortec uses on the mustang kits. Since the waste gate boost source is self contained and isolated it will not cause a vaccum leak. It will just bleed off a certain cfm from the waste gate acuator so it will take 10psi to open a 7 psi gate. I use a ball and spring type like in the link. The bleed type tends to spike less from what I used. I had one but it didn't have a big enough bleed hole to relieve boost through so it only upped my boost 2 psi, insted of the 4 I needed it to.