had 9.5psi now only 5psi were did it go??
#1
had 9.5psi now only 5psi were did it go??
d16y7 with teo4h with internal wastgate
i had a consistent 9.5 psi for first few days. then all of a sudden all i can get is 5psi. if i unhook the wastgate i get 7-8psi. i looked n looked for any leaks anywhere n cant find anything. the wastegate does close as far as i can tell. i am running the factory pcv setup. could this be where my problem lies? take it easy on me this is my first boost experience lol
i had a consistent 9.5 psi for first few days. then all of a sudden all i can get is 5psi. if i unhook the wastgate i get 7-8psi. i looked n looked for any leaks anywhere n cant find anything. the wastegate does close as far as i can tell. i am running the factory pcv setup. could this be where my problem lies? take it easy on me this is my first boost experience lol
#2
It seems to me that there may be a leak in the diaphragm of the wastegate actuator thingy lol. Is this unheard of? I say that cause it is back to bout atleast 9.5 psi not hooked up but hooked up it goes up to 6psi then drops to 5 n stays there. Plz any help would be much appreciated. Thanx
#5
I didn't know it was adjustable. I just tried unhooking it n turning it. But it didn't seem like it moved. N it still only hit 5psi. So I made a controller to put in the line from the turbo to the actuator. N the no psi when unhooked problem was a plugged exhaust. Was pieces of cat coming out the exhaust. Which is weird cause this car hasn't had a cat for yrs. Anyway I think I'm back on track the controller seems to work good so far.
Thread
Thread Starter
Forum
Replies
Last Post
lilpooh21186
General Discussion
22
08-22-2007 01:06 PM
playboyace35
Forced Induction
18
05-08-2004 07:40 PM