h22/je pistons/eagle rods

Reply Subscribe

Thread Tools

Search this Thread

Jul 28, 2004 | 06:39 PM

EG_SiCKNeSS

Guest

Posts: n/a

h22/je pistons/eagle rods

how much boost can i push on a jdm h22a block w/ je 9.0:1 pistons and eagle h-beam rods? fuel manangement is uberdata/550cc/255lph pump. i was thinking of running 12psi daily and 15psi at the track but is that a bit high on the stock sleeves?

Jul 28, 2004 | 07:14 PM

EG_SiCKNeSS

Guest

Posts: n/a

Re:h22/je pistons/eagle rods

somebody answer dammit!

Jul 28, 2004 | 07:14 PM

mahcivic

3.0 BAR

Joined: Jan 2004

Posts: 2,238

Re:h22/je pistons/eagle rods

i thought you had to sleeve h22s if you were gonna biuld them...but im usually wrong

Jul 28, 2004 | 07:20 PM

Semnos

3.0 BAR

Joined: Dec 2002

Posts: 3,828

Re:h22/je pistons/eagle rods

You are right...You need to put new sleeves in.
H-series engine use FRM sleeves.(hope I got it right)
It's properties are not suited for forged pistons.

Jul 28, 2004 | 07:21 PM

EG_SiCKNeSS

Guest

Posts: n/a

Re:h22/je pistons/eagle rods

hmmm...scratch that. will i be able to safely run 12psi on stock bottom end with top notch engine management? or is 12 just too much?

Jul 28, 2004 | 08:46 PM

Reddy

0.0 BAR

Joined: Jun 2003

Posts: 0

Re:h22/je pistons/eagle rods

H22's are once and done detonation motors. It takes very little to snap ringlands. But good fuel management will help you to avoid this problem.

My advise, have some stock pistons laying around and just put a new one in when one goes.

Jul 28, 2004 | 11:03 PM

AgentMurdoc

3.0 BAR

Joined: Dec 2002

Posts: 9,191

Re:h22/je pistons/eagle rods

yo I'm the o.g. khmer **** on this site

j/k :P Good to see another on the site, if you really are khmer. :P

Jul 28, 2004 | 11:34 PM

EG_SiCKNeSS

Guest

Posts: n/a

Re:h22/je pistons/eagle rods

dam, why does the h22's gotta be so sensitive, im **** now.

Jul 28, 2004 | 11:37 PM

HMT-Admin

Administrator

Joined: Dec 2002

Posts: 13,988

Re:h22/je pistons/eagle rods

They are just as sensitive as any other honda engine. Cast pistons make them weak. The FRM (fiber re-inforced metal) sleeves are homo and wont work correctly if you put a aftermarket piston in. I say boost the h22 around 10psi perfectly tuned, and have some money in the bank for sleeves/rods/pistons =)